Removing the Accelerator Pedal Assembly
Pic. 2.214. Steering column pad
Remove the steering column cover (pic. 2.214).
Pry off the plug with a screwdriver.
Loosen the fixing screw.
Pic. 2.215. Installation of a master key
Insert, as shown in Figure 2.215, all the way into the special holes and remove the accelerator pedal assembly.
Disconnect the electrical plug and release the wire from the pedal assembly.
Installing the Accelerator Pedal Assembly
Pic. 2.216. Accelerator Pedal Assembly Installation Diagram
Insert the wire guide tab 1 and connect the plug 2 to the accelerator pedal assembly (pic. 2.216).
Install the accelerator pedal assembly to the mounting bolts 6.
Insert dowel pin 7 into the hole in the bottom.
Screw the accelerator pedal assembly with bolt 3 with a tightening torque of 10 Nm.
Attach cap 4.
Establish an overlay of a steering column.
Visitor comments