Design and specifications Electrical equipment is made on a single-wire circuit. Negative conclusions of consumers and sources of electricity are connected to «weight», acting as the second wire. Mains...
Technical characteristics of the battery Depending on the model, batteries with a nominal voltage of 12 V and a nominal capacity of 36, 45, 54 and 63 Ah were installed on the cars. The positive terminal of the battery is...
Generator Specifications The cars were equipped with a three-phase alternator brand Bosch (some cars were equipped with a Motorola brand generator with similar characteristics) type K1 14V with built-in...
Starter Specifications The vehicles are equipped with a starter consisting of a four-pole DC motor with series excitation and a traction relay. The armature shaft rotates in self-lubricating bushings....
Technical characteristics of fuses The fuses are located in the mounting block installed in the passenger compartment under the storage shelf on the left side of the instrument panel. Circuits protected by fuses...
Removal and installation of the generator Disconnect the wire from the negative battery terminal. Disconnect the electrical wires from the generator clamps. Loosen the alternator mounting bolt and the alternator mounting...
Disassembly and assembly of the generator Disassembling and assembling the generator is not particularly difficult (be guided by the detailed view, which shows the sequence of removal and installation of parts). When...
Alternator Drive Belt Tension Adjustment Loosen bolt 1 (see photo) fastening of the generator and a nut of fastening of the generator to a tension level 2. Move the generator away from the engine so that the belt...
Removal and installation of a starter On vehicles with 4-cylinder engines Disconnect the wire from the negative battery terminal. Disconnect the wires from the starter clamps. Loosen the starter mounting bracket...
Disassembly and assembly of the starter Disassembly and assembly of the starter is not particularly difficult. Be guided by the given detailed view. When inspecting parts, check: the condition and degree of wear of the...
Removal and installation of the windshield wiper motor Disconnect the wire from the negative battery terminal. Remove both wiper arms. Loosen the nuts on the axles of the wiper arms. Loosen the windshield wiper bracket bolts. Remove...
Removal and installation of a combination of devices Disconnect the wire from the negative battery terminal. Remove the steering wheel cover. On vehicles with mechanical steering, carefully pry off the horn buttons with a...
Headlight adjustment It is best to adjust the headlights with the help of mobile optical instruments. In their absence, adjustment can be made using the screen. The headlight beam is adjusted by...
Removal and installation of a heater Disconnect the wire from the negative battery terminal. Remove fan shroud. Remove the additional resistor. Loosen the fan mounting bolt. Remove fan. Clamp the heater hoses....