Electrical equipment and devices of car Volkswagen Sharan 1

General information about on-board electrical equipment
The electrical equipment of the Sharan car is made according to a single-wire scheme - the negative terminals of the sources and consumers of electricity are connected to the...

Windscreen wipers — design description
Fig. 345. Windscreen wiper mechanism: 1 - brush; 2 - nut, 20 Nm (15 mm wrench); 3 - washer; 4 - nut, 20 Nm (32 mm wrench); 5 - washer; 6 - rubber gasket; 7 - gear motor; 8 -...

Replacing the windshield wiper arm
Replacement wiper arm in the following order: turn off the windshield wiper; slide the protective cover and loosen the hex nut that has become visible (don't turn it completely...

Replacing the rubber band of the wiper blade and the wiper blade itself
As a rule, the service life of the rubber band of the windshield wiper blade is about 6 months of operation, after which the quality of cleaning the windshield deteriorates and it...

Replacing the windshield wiper gear motor
It is recommended to replace a faulty gear motor with a new one. The only repairs allowed for the gear motor are replacing the gear reducer pinion, cleaning the collector and...

Headlights — General Information
The Sharan uses various halogen lamps as light sources, which have, compared to conventional lamps, greater light output and an increased service life. The main parts of the...

Replacing headlight bulbs
The headlight bulbs are removed from the engine compartment side of the engine. Replacing the bulb does not change the headlight alignment. Attention! When replacing headlight...

Removal and installation headlights
Removal headlights are installed in the following order: remove the turn signal next to the headlight ( see subsection 16.7 ); remove the radiator grille: unscrew the four bolts...

Disassembling and assembling the headlight
Fig. 350. Individual elements of the headlight: 1 - screw, 8 Nm; 2 - locking clamp; 3 - headlight housing; 4 - ventilation device; 5 - lid; 6 - side light bulb socket; 7 - double...

Headlight adjustment
The headlights are adjusted by turning the adjusting screws, which turn the optical element in the vertical and horizontal planes. At the service station, the headlights are...

Rear lights — removal and installation
Fig. 352. Rear light parts: 1 - rubber sealing gasket; 2 - direction indicator bulb, 21 V; 3 - incandescent lamp socket; 4 - rear side light bulb, 21 V; 5 - dual-filament brake...

Replacing front turn signal bulbs
Replacement replace the front turn signal lamps in the following order: Fig. 357. Front direction indicator light mounting location (shown by arrow) open the hood and unscrew the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian