Mechanical gearbox and shafts of car Volkswagen Sharan 1

5-speed manual transmission
A five-speed manual gearbox, type 006, is fitted to all Sharan models, regardless of engine type. However, there are differences in gear ratios, which vary between engines. The...

Removal the gearbox
Removal of the gearbox can be done without removing the engine downwards. Removal of the gearbox is necessary when repairing or replacing the clutch or the gearbox itself. The...

Gearbox installation
Install the gearbox in the reverse order of removal, observing the following points: clean the splined connections of the drive shaft and treat with lubricant G 000 100; if the...

Gear shift mechanism
The traditionally used gearshift rods on the Sharan have been replaced by two cable rods. As a result, the vibrations transmitted to the gearshift lever and into the car's...

Replacing gear shift cables
Note: Before attempting to replace the two shift cables, read all instructions regarding the job. Many of the operations are quite complex and difficult for an inexperienced...

Checking the functionality of the gear shift mechanism
Before checking the operation of the gear shift mechanism, make sure that: all elements of the gear shift drive are in good condition, move easily, without jamming; both gear...

Checking the gearbox oil level
To check the gearbox oil level, follow these steps: turn the steering wheel all the way to the left; remove the lower engine compartment cover; Fig. 257. Location of the plug for...

Wheel Drive Shafts — Design Description
The drive shafts of the right and left wheels are different. In this case: the outer constant velocity joint (CV joint) is the same for both drive shafts. If damaged, replace it...

Removal and installation the drive shaft (manual transmission)
Caution! If you have removed the hexagonal flange bolt, use a new bolt when installing. The weight of the vehicle should not be on the wheels, as this may damage the wheel...

Removal and installation the drive shaft (automatic transmission)
Caution! If you have removed the hexagonal flange bolt, use a new bolt when installing. The weight of the vehicle should not be on the wheels, as this may damage the wheel...

Drive shaft repair
Faulty constant velocity joints can be identified by creaking or cracking sounds when the front wheels are turned hard while the vehicle is moving. In this case: Fig. 258. Wheel...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian