Car manual introduction Volkswagen Sharan 1

Minivan VW Sharan — annotation
This manual is a guide to repairing VW Sharan and Ford Galaxy cars, produced since February 1995 as a result of the joint work of the companies "Volkswagen" and "Ford". The...

Vehicle identification
Nameplate is located on the right middle pillar under the door lock. The chassis number, stamped on the engine compartment bulkhead, in addition to the current production number,...

General recommendations for car repair
All descriptions in this repair manual are clear and simple enough. The reference tables provided at the end of the book are very important and should be used when performing...

Conditions of work and tools used
It is best to carry out repair work in a clean, well-lit place where there is a workbench and a vice. There should also be enough free space to be able to lay out the various...

Correct lifting of the car
Fig. 7. Jack installation location on the front of the body The car is lifted using a jack from the driver's tool kit, a garage jack or a stationary lift at a service station. The...

Lubricants and sealants
Each car manufacturer recommends the use of certain lubricants that are targeted at a specific car brand. This also applies to products "Volkswagen", and it is for this reason...

Rules for handling threaded connections, bolts, nuts
A new car and, accordingly, the engine will have no problems with loosening screws, nuts, bolts, etc. If the car is no longer new, then difficulties arise with loosening threaded...

Appendix 1. Technical data and characteristics
Engine 2.0 l Engine designation - ADY Design: 4-cylinder, four-stroke, in-line. The camshaft is driven by a toothed belt. Working volume - 1998 cm³ Power - 85 kW (115 hp) at 6000...

Appendix 2. Basic data for adjustments and control
Engine 2.0 l Nominal cylinder diameter - 82.51 mm Piston dimensions: Fig. 131. Sectional view of the piston: a = 21.3 mm; b = 5.0 mm; c = 62.9 mm; d = 21.0 mm "a" (Fig. 131) -...

Appendix 3. Tightening torques for threaded connections
VR6 Engine Cylinder head mounting bolts: first stage - 40 Nm second stage - 60 Nm third stage - Turn another 180° Connecting rod bearing cap bolts - 30 Nm, +90° Main bearing cap -...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar sections from other manuals for VW cars:
General information: Introduction to instructions Volkswagen Passat B2 (1981-1988)
General information: Introduction to guide Volkswagen Golf 2 (1984-1993)