Car suspension repair Volkswagen Sharan 1

Front suspension — general information
The front suspension of the Volkswagen Sharan is independent spring, MacPherson type, with transverse levers and with a stabilizer bar. The diameter of the stabilizer bar is 20...

Removal and installation the front suspension
Fig. 279. Removing and installing the wheel hub bearing, shock absorber strut and drive shaft: 1 - bolt, 110 Nm (always replace); 2 - steering knuckle; 3 - bolt; 4 - bolt, 5 Nm; 5...

Front suspension repair
Fig. 287. Shock absorber strut: 1 - shock absorber; 2 - rubber buffer; 3 - protective cover; 4 - coil spring; 5 - upper spring support cup; 6 - thrust bearing; 7 - nut, 60 Nm; 8 -...

Coil spring and shock absorber
Shock absorbers and coil springs are color coded. Always install the spring with the correct marking. Gas-filled shock absorbers are installed on all vehicles. Shock absorbers can...

Replacing wheel bearings
If you remove the wheel bearing, it will be destroyed. Therefore, you cannot press out the wheel bearing to check its condition. To remove the wheel bearing housing, see section...

Removal and installation transverse arms
Fig. 291. Fastening the transverse arm, anti-roll bar and pendulum support to the subframe: 1 - subframe; 2 - nut, 55 Nm; 3 - rubber support; 4 - self-locking nut, 100 Nm (always...

Anti-roll bar
The method of fastening the anti-roll bar is shown in Figure 291. In order to gain access to the anti-roll bar, remove the subframe and pendulum support: place the front of the...

Adjusting the front wheel alignment angles
Adjustment of the front wheel alignment angles should be performed on a vehicle with a working load. Before adjustment, check that the ball joints of the transverse steering rods...

Rear suspension — design description
Fig. 297. Rear suspension: 1 - subframe (cross beam); 2 - anti-roll bar; 3 - spring; 4 - wheel hub block; 5 - lower arm; 6 - shock absorber Fig. 297 shows the rear suspension...

Removal and installation the rear suspension
The order of operations: loosen the rear wheel mounting bolts, place the rear of the car on supports and remove the wheels; disconnect the parking brake cables ( see section...

Trailing arm / suspension springs
When removing the longitudinal arm, the coil spring is also removed: place the rear of the car on stands and remove the rear wheels; Fig. 305. Bottom view of the parking brake...

Removal and installation shock absorbers
Fig. 307. Lower shock absorber mount. Upper mount looks similar. Tightening torque 130 N·m Removal and installation of shock absorbers can be carried out using the given...

Rear wheel bearings
Fig. 308. Rear wheel bearing housing: 1 - wheel bolt, 140 Nm; 2 - bolt, 10 Nm; 3 - brake disc; 4 - wheel hub bolt; 5 - washer; 6 - wheel hub; 7 - bearing retaining ring; 8 - wheel...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian