Car automatic transmission Volkswagen Passat B6

Gearbox Description
Fig. 3.66. Letter designations of automatic transmissions the "6-speed automatic transmission 09G" has 6 forward gears with hydraulic control. Due to the slippage of the torque...

Gearbox marking
"Automatic 6-speed gearbox 09G" has been installed on Passat cars since 2006. Marking on the gearbox Fig. 3.65. Location of the automatic transmission letter designation The...

Planetary gear and final drive
Letter designations, identification of units, gear ratios of the gearbox of the Passat car of the 2006 model Removing and installing the torque converter sealing ring Removal Fig....

Checking the ATF fluid level and topping up
Fig. 3.69. Threaded plug sealing ring When checking the ATF level, it is essential to replace the sealing ring of the ATF level control plug (Fig. 3.69). Turn off the engine. At...

Draining and filling ATF
Turn off the engine. Fig. 3.70. Unscrewing the ATF level check plug Remove the ATF level check plug from the oil pan (Fig. 3.70). Fig. 3.72. Bypass tube Remove the bypass tube 1...

Electrical/electronic components and their installation location
Fig. 3.73. Automatic transmission components installed on the vehicle: 1 – Automatic transmission control unit; 2 – engine control unit; 3 – Multifunctional sensor; 4 –...

Removal the gearbox control lever with selector
Fig. 3.83. Components of the automatic transmission gear shift mechanism: 1 – case with handle; 2 – gearbox control lever with selector; 3 – screw with spring; 4 – pins; 5 –...

Removal and installation the gear selector cable
Note: Set the selector lever to the "S" position. Removal Fig. 3.84. Unlocking the cable Press cable 1 away from lever 3 using key 2 (Fig. 3.84). Squeeze the clamps and remove the...

Checking the selector lever cable
To check the free movement of the selector lever cable, it must be disconnected from the gearbox and the disconnected end placed so that it does not touch anything. Move the...

Adjusting the selector lever cable
The selector lever cable needs to be adjusted if the selector lever cable was disconnected from the gearbox. Either the engine and/or transmission has been removed/installed. If...

Removal and installation the handle
All types of handles have the ability to recess the button into the handle. Do not install a handle with a recessed button. Fig. 3.86. Removing the button Before removing, pull...

Checking the gear shift mechanism
When the selector is in positions "R", "D" and "S", the starter must be locked. On vehicles with the steering wheel on the right side, the starter can be turned on in the selector...

Gearbox removal, Passat 2006 with «external» water ATF cooling radiator
When removing the gearbox without the engine, it drops down. The engine remains installed in the car. the battery cover, air filter and engine cover are removed from above. Then...

Gearbox installation, Passat 2006 with «external» ATF cooling radiator
Installation is carried out in principle in the reverse order, however the following instructions should be followed. Check if the centering bushings are pressed onto the engine...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Passat B6 Passat B5 Passat B4

Passat B3 Passat B2