Automatic transmission 09M car Volkswagen Tiguan 1

Marking on the gearbox
Letter designation of gearbox 09M Letter designation "arrow 1". Automatic 6-speed gearbox 09G "arrow 2". The letter designations of the gearbox are also present on the factory...

Letter designation, compatibility of units
Letter designation, compatibility of units - cars with front-wheel drive Letter designation, automatic transmission 09M Engine JWA 2.0 l - 147 kW TFSI Letter designation,...

Electrical and electronic units and parts and their installation locations
1 - Automatic transmission control unit "J217". The control unit transmits and receives data from the data bus, can be checked by guided fault finding with -VAS 5051- 2 - Engine...

Removal the F125 multifunction switch
Shift the selector to position N. Switch off the ignition. Do not open the cooling system. Squeeze the locks of the selector rod "3" and pull the rod out of the support upwards....

Overview of the switching drive
1 - Gearshift cover with handle. Emergency release: Before removing the handle, pull out the button through the pressure point and secure with adhesive tape. This will prevent the...

Checking the cable traction
To check the cable traction for ease of movement, first remove it from the gearbox and place the disconnected end so that it does not touch other components and parts. Then switch...

Emergency release of the selector
Do not remove the handle. Unclip the gearshift boot and set it aside. Press the brake pedal or apply the handbrake. Move the yellow plastic element from right to left. The...

Checking the gear shift drive
In selector positions R, D and S, it is prohibited to engage the starter. In right-hand drive vehicles, it is permitted to engage the starter in selector positions P and N only...

Gearbox Removal — 2.0L 147kW TSFI Engine Vehicles
Do not remove the subframe for units. Raise the car. All four legs of the lift should be at the same height. Turn the steering to the middle position. Remove the ignition key and...

ATF radiator
1 - ATF radiator 2 - The supply line is connected to the ATF radiator using a quick-release coupling 3 - Drain line, connected to the ATF radiator using a quick-release coupling 4...

Removal and installation the ATF radiator
Removal Remove the sound insulation. Remove the radiator grille. Press the filler pipe "1" of the windshield washer out of the bracket "A" and fix it behind the headlight. Remove...

Draining and filling ATF
Turn off the engine. Unscrew the threaded plug for checking the ATF in the pan "arrow". Remove the bypass tube "1" through the inspection hole. Drain the ATF oil. Install the...

Electrohydraulic unit of the gearbox
1 - ATF level control screw plug 2 - O-ring, always replace 3 - Overflow tube, unscrew to drain ATF oil 4 - Oil pan 5 - Bolt, tighten the oil pan bolts in several stages in a...

Removal and installation the wiring harness for the solenoid valves and sensors
Drain the ATF. Remove the oil pan. Remove the mesh oil filter. Remove the electrohydraulic unit. Disconnect the connector from the gearbox "1" connector for the sensors in the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian