Steering column Before removing parts, thoroughly clean the joints and adjacent areas. When installing the steering gear, make sure that all centering bushings installed between the subframe and...
Removal and installation the steering wheel Removal Remove the driver's side airbag module. Disconnect connector "1" of the spiral cable. Set the steering wheel to the center position (the wheels must be straight). Unscrew...
Removal and installation the steering column Steering columns are supplied only as an assembly. Steering column repair is not allowed. Ignition switch housing can be replaced. ATTENTION: It is necessary to remove the...
Steering gear with electromechanical power steering 1 - Cardan joint 2 - Bolt, M8x35, 30 Nm, replace after each removal 3 - Power steering with power steering control unit "J500", with electromechanical power steering motor "V187",...
Removal and installation the steering gear Removal Disconnect the battery. Remove the footwell trim "1" by unscrewing the nuts "arrows". Loosen bolt "1" and remove cardan joint "2" from the steering gear shaft. Remove the...
Removal and installation the corrugated cover Removal Instructions: If the bellows is damaged, moisture and dirt penetrate into the steering gear. There should be a film of grease on the rack teeth that can be felt. If there...
Removal and installation the steering rod Removal Set the wheels in the Straight ahead position. Clean the steering gear in the area of the corrugated boot. Hold the steering rod end "arrow 2" from turning and loosen the...