Car steering Volkswagen Touareg 1

Removal and installation the steering column
Fig. 5.1. Steering column components: 1 - steering column cross beam; 2 - self-locking nut; 3 - screw with internal star; 4 - steering column; 5 - Hexagon head bolt; 6 - handle; 7...

Removal and installation the sealing cuff
Removal Clamp the steering column in a vice as shown in the figure. Mark the position of the top relative to the bottom. Pull the lower part away from the upper part with a...

Removal and installation the power steering drive
Fig. 5.11. Steering gear components: 1 - Hexagon head bolt; 2 - screen; 3 - screen; 4 - cardan joint; 5 - Hexagon head bolt; 6 - Power steering; 7 - subframe; 8 - Hexagon head...

Removal and installation the steering rod
Removal The left and right steering rods are identical. Their removal and installation are carried out without dismantling the steering control. Remove the front wheel. Press the...

Vane pump, 5-cyl. diesel engine
Repair work for the vane pump is not provided. In case of failure, its cause is determined by hydraulic testing and leak testing. In case of failure, the vane pump is subject to...

Removal and installation vane pump, 5-cyl. diesel engine
Fig. 5.21. Components of a vane pump: 1 - cylinder block: 2 - sealing ring; 3 - impeller pump; 4 - bolt; 5 - coupling; 6 - spring clamp; 7 - suction hose; 8 - sealing rings,...

Removal and installation vane pump, 6-cyl. diesel engine
Fig. 5.30. Components of a vane pump: 1 - impeller pump; 2 - belt pulley; 3 - Allen screw; 4 - holder; 5 - Allen screw; 6 - hollow bolt; 7 - sealing rings, 16 x 22; 8 - pressure...

Removal and installation vane pump, 6-cyl. petrol engine
Fig. 5.35. Components of a vane pump: 1 - hollow bolt, 40 Nm; 2 - sealing rings, 16x22; 3 - pressure hose; 4 - suction hose; 5 - spring clamp; 6 - impeller pump; 7 - adjusting...

Bleeding the steering system and checking for leaks
Bleeding the steering system Check the hydraulic oil level and top up if necessary. Raise the vehicle so that the front wheels are free. Start the engine and let it idle for about...

Checking the steering system for leaks
NOTE: It is necessary to check the tightness of the steering system after installation work and when there is no oil in the reservoir. Start the engine. Turn the steering wheel in...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian