Car driveshaft Volkswagen Touareg 1

Cardan shaft and front final drive
Fig. 3.128. Cardan shaft and front final drive: 1 - front final drive: 2 - gasket 3 - bolt, 30 Nm 90°; 4 - front propeller shaft; 5 - transfer case; 6 - hex nut; 7 - hinge disk; 8...

Removal and installation the front propeller shaft
Work on the front propeller shaft must be carried out on a two-support lift with a platform. Before dismantling, mark the position of all parts in relation to each other. Assembly...

Removal and installation the rear propeller shaft
Work on the rear propeller shaft must be carried out on a two-support lift with a platform. Before dismantling, mark the position of all parts in relation to each other. Assembly...

Checking the oil level in the rear main gear
Remove the oil level check bolt (fig. 3.143). The oil level is sufficient if it is within the lower edge of the filler hole of the rear final drive. Tighten the bolt with a new...

Removal the front final drive
Loosen the wheel bolts. Raise the car. Remove the front wheels. Remove the front right and left fender liners. If the vehicles are equipped with air shock absorbers, it is...

Installing the front final drive
Installation is carried out in the reverse order, taking into account the following. Always replace the front propeller shaft mounting bolts. A second mechanic is required to...

Installing the Front Main Gear Ventilation Tube
The ventilation tube 1 runs from the front main gear 3 behind the right engine mount 4 to the air filter 2 and is clipped onto it (fig. 3.157).

Replacing the sealing ring of the left shaft with flange
Removal Remove the front final drive. Attach the VW 771 universal tool to the left flange shaft. Remove the left shaft with flange (fig. 3.158). Remove the flange shaft seal ring...

Replacing the shaft boot with flange
Press out boot B from the flange shaft (fig. 3.162). A - Puller 22-115 mm, for example Kukko 17/2. Press in the shaft boot A with flange (fig. 3.163). Install bushing 3301/3 with...

Replacing the rubber-metal support of the front main gear
Mounting position of the rubber-metal support. Rubber-metal support with 2 recesses (fig. 3.167). NOTE: The support recesses must be vertical to the final drive. Rubber-metal...

Replacing the left flange shaft seal ring for vehicles without differential lock
Removal Remove the rear final drive. Attach the VW771 universal tool to the left flange shaft. Remove the left shaft with flange (fig. 3.169). Remove the flange shaft seal ring...

Replacing the left flange shaft seal ring for vehicles with differential lock
Removal Remove the rear final drive. Attach the VW 771 universal tool to the left flange shaft. Remove the left shaft with flange ( fig. 3.169 ). Remove the flange shaft seal ring...

Removal and installation the drive shaft
Fig. 3.173. Drive shaft: 1 - drive shaft; 2 - clamp; 3 - joint boot; 4 - clamp; 5 - retaining ring; 6 - Outer CV joint; 7 - screw with internal star; 8 - backing plate; 9 - inner...

Disassembling the drive shaft
Removal the outer hinge Remove both clamps from the joint boot. Remove the boot from the outer joint. Separate the outer joint from the drive shaft by hitting the joint hard with...

Drive shaft assembly
Press the inner joint onto the drive shaft as shown in Figure 3.184. Install a new snap ring onto the drive shaft using the VW 161 A snap ring collet. Install the new cover onto...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar sections from other manuals for VW cars:
Transmission: Cardan shaft Volkswagen LT 28 (1975-1991)