Car engine lubrication system Volkswagen Touareg 1

Removal and installation of lubrication system elements (petrol engine)
NOTE: For installation work, the engine must be secured to the K4S 6095 engine and gearbox retainer. NOTE: The oil level must not exceed the Max mark - risk of damage to the...

Removal and installation oil injector (petrol engine)
NOTE: Oil jets are installed in crankshaft main bearings 2-7. Removal Press out the oil nozzle by applying pressure with a 4 mm pin towards the engine bearing. Installation For...

Removal and installation the oil drain check valve (petrol engine)
Removal Screw a standard M8x1.5 bolt into the valve approximately 4 turns -arrow-, and pull the valve out of the hole. Installation Before installation, wet the O-ring with engine...

Disassembly and assembly of the oil pump (petrol engine)
Fig. 2.253. Oil pump components: 1 - drive shaft; 2 - oil pump housing - bolt 23 Nm; 4 - stars; 5 - oil pump cover with safety valve; 6 - bolt 8 Nm; 7 - pressure oil line; 8 -...

Removal and installation the oil pan (petrol engine)
Removal Drain the engine oil. NOTE: Follow proper disposal procedures. Disconnect the connecting tube to the air suspension compressor at the air filter. Remove the air filter...

Checking the oil pressure sensor (petrol engine)
Verification conditions The engine oil temperature must be at least 80°C (the cooling fan should run at least once). In vehicles with automatic transmission, move the selector...

Checking oil pressure (petrol engine)
Verification conditions The engine oil temperature must be at least 80°C (the cooling fan should run at least once) In vehicles with automatic transmission, move the selector...

Checking the engine oil level (diesel engine)
Markings on the oil dipstick 1 - Max mark. 2 - Min mark. a - Section above the shaded field to the max mark: Do not add engine oil. b - Current level in the shaded field: engine...

Oil lines in the oil pan (diesel engine)
Fig. 2.260. Components of the oil pan: 1 - bolt 8 Nm; 2 - bolt 8 Nm; 3 - Engine oil level and temperature sensor G266; 4 - sealing cuff; 5 - oil drain plug, 30 Nm; 6 - oil pan; 7...

Application of sealant (diesel engine)
Work execution procedure Remove any remaining sealant from the oil pan using a rotating brush attachment, such as a hand drill with a plastic bristle brush attachment kit (put on...

Unscrewing and screwing the oil filter cover (diesel engine)
Fig. 2.266. Oil filter components: 1 - oil filter housing cover, 25 Nm; 2 - oil filter; 3 - lid; 4 - upper part of the body; 5 - bolt 8 Nm; 6 - bolt 10 Nm; 7 - seal; 8 - filler...

Checking oil pressure and oil pressure sensor (diesel engine)
Cars with engine letter designations AYH, BKW Remove the fuel filter. Cars with BLE and BWF engines Remove the bypass cover with the EGR cooler. Continuation of installation...

Checking the oil pressure at the front of the engine (diesel engine)
Verification procedure Remove the engine compartment covers. Remove the sound insulation from the cylinder heads. Unscrew the threaded plug A of the oil channel of the cylinder...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian