Car steering VW Transporter T3

Description of the steering design
The bus is equipped with rack and pinion steering, the steering drive of which is filled with a special long-lasting lubricant. Work on the steering must be carried out in a...

Removal and installation the steering wheel
Dismantling Set the wheels straight. Remove the cover from the steering wheel manually and remove the contact. Unscrew the hex nut and disengage the steering wheel with your hand....

Hydraulic booster — design description
Steering is facilitated by the use of a power steering system. The hydraulic power steering consists of an oil pump (vane pump), oil reservoir and oil pressure lines. The oil pump...

Checking the servo control for leaks
If there is a lack of hydraulic oil in the leveling reservoir, it is necessary to check the control system for leaks. Start the engine and let it idle. Turn the steering wheel in...

Checking the servo oil level
The hydraulic drive oil level should be checked every 30,000 km. Start the engine and let it idle. (825-354) Check the oil level in the equalizing tank with the wheels straight....

Checking the steering
Leave the car on wheels. Turn the steering wheel back and forth. In this case, steering should occur without play; if this is not the case, contact a workshop to check the...

Removal and installation the transverse steering rod
Dismantling Loosen the wheel bolts, raise the front of the car, and remove the wheel. On the head of the transverse steering rod, pull out the cotter pin, unscrew the nut with...

Steering gear and tie rod
Instructions: 1. Welding and straightening work on steering components is not permitted. 2. For lubrication, use only AOF 06300004 steering grease in a 1 kg can. (1) Steering...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3