Elements of body and interior of car VW Transporter T3

Removal and installation the front bumper
The bus body is load-bearing. The bottom, side and roof are welded together. Therefore, complex bodywork must be carried out in a workshop. Dismantling Remove the screws (1) from...

Removal and installation the rear bumper
Dismantling (63-027) Unscrew two hex bolts (arrows) from the beam on each side and pull the buffer back. Installation Install the buffer, straighten it and screw it on.

Removal and installation the driver's seat
Dismantling (72-063) Pull the locking spring 1 upwards and move the seat forward. Use a screwdriver to push the locking lever upward and slide the seat out of the guide rails....

Camping Equipment — Safety Precautions
Attention! When working with additional electrical equipment in a touring vehicle, the following safety precautions must be observed: Never assemble or disassemble 220V sockets...

Checking the indicator lights of camping equipment
1. Check the readiness and battery status indicator lights: dismantle the indicator device. (97-682) connect the device to a charged 12 V car battery. Red wire 1 to the positive...

Testing the water pump of camping equipment
If there is a malfunction - the water pump does not work - in addition to checking the water level, connections and electrical fuses, you must follow these instructions: Check the...

Dismantling and installation of a water tap
Dismantling Remove the drawer from the kitchen cabinet. Remove the shelf. (76-092) Loosen clamp 1 and remove the pressure hose. (76-093) Disconnect plug connection 2. Unscrew the...

Dismantling and installation of the central locking servomotor
Dismantling Remove the door trim. Remove the protective sheet. (57-226) remove the plug connection from the motor. Disconnect spring 1 from locking rod 4. Press the locking rod 4...

Description of the design of the cabin heating system
In a diesel Volkswagen bus, the coolant passes through a heat exchanger to heat the cabin. Temperature regulation occurs by mixing cold and warm air. An electric air blower is...

Adjustment of fresh air and heating ducts
(1) heating and ventilation (2) fresh air and heating regulation (3) regulating valve (4) Air duct. Built into buses without additional heating system. Subsequent installation in...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar sections from other manuals for VW cars:
Body: Body elements Volkswagen Passat B4 (1988-1996)
Body: Body elements Volkswagen Golf 2 (1984-1993)
Body: Body elements Volkswagen LT 28 (1975-1991)

Transporter T4 Transporter T3