Contents: Dismantling ↓ Installation ↓
Dismantling
Remove the door trim.
Remove the protective sheet.
(57-226) remove the plug connection from the motor.
Disconnect spring 1 from locking rod 4.
Press the locking rod 4 out of the locking rod cover 5.
(57-227) unscrew two screws 8 and pull out the servomotor.
If you need to remove the bearing sheet from the motor, you need to drill out three hollow rivets (in the picture on the right), and during installation, replace them with new ones or use bolts.
Installation
Connect the plug to the motor.
Insert the servomotor into the door and hang the rod system.
(The information is presented on the website www.VWmanual.ru)
Attach the motor with two screws.
Check the functioning of the central locking and lock.
Install door trim.
Visitor comments