Doors, locks and windows of car VW Transporter T3

Dismantling and installation of door trim
Dismantling is carried out in the order of numbers in Figure 70-052, installation is in the reverse order. (1) Window lift handle. 1 x countersunk head screw (2) door handle. 4...

Replacing the glass of the external mirror
If the mirror glass is broken, the entire rearview mirror is usually replaced. But if it is an electrically controlled and heated mirror, only the glass is replaced. Flat and...

Dismantling and installation of the front door
Dismantling is carried out in the order of the numbers in the figure, installation is in the reverse order. (1) Internal door latch with rod (2) Latch Seal (3) Door handle. 1...

Dismantling and installation of a door window
Dismantling Remove the door trim, see above , lower the window a little. (57-129) unscrew the glass from the window regulator (arrows). Unscrew the leading strip at the top from...

Removal and installation of window regulator
Dismantling Remove door trim, see above. Lower the window. Unscrew the window from the window lifter, see Fig. 57-129. With manual control: (57-131) Unscrew the hex bolt (arrow)...

Removal and installation of corner glass
Dismantling Remove the door trim, see above . Remove the door window, see above . (57-134) remove the door seal and unscrew the leading strip bolt (arrow). (57-135) unscrew the...

Removal and installation the lock cylinder
Dismantling (57-126) open the door, remove the door seal, unscrew the screw (arrow). Remove the door handle. If you need to remove the lock cylinder, pull the pin out of the...

Front door adjustment
The front door is installed correctly if, when closed, it is at the same distance from the door opening everywhere. The relief waist line of the door should match the same line of...

Removal and installation sliding door trim
Since September 1984, a structurally modified sliding door has been installed. The following sections describe the installation and repair work on this door. Dismantling Remove...

Dismantling and installation of a sliding door
Dismantling Remove the sliding door trim. (58-223) Move the door back so that the roller carriage is under the bulge of the guide rail (arrow). Raise the rear part of the door and...

Sliding door adjustment
Adjustment work on a sliding door must be carried out by two people. A sliding door is installed correctly if, when closed, it is at the same distance from the doorway everywhere....

Adjustment of the sliding door of buses with increased cabin height
Only installation work is described here, which differs from similar work with a serial door. Before adjustment, all installation work for a serial door described above must be...

Removal and installation of a remote control lock
(1) External door handle (2) socket (3) spacer washer (4) interior door handle (for a van) (5) cap (6) screw M5x15* (7) interior door handle (for the bus) (8) safety button (9)...

Dismantling and installation of the central lock
Dismantling Please note: The central lock can be removed and inserted with the sliding door installed and open. (1) central locking (2) Hexagon bolts M8x40, tightening torque...

Replacement of worn parts of the articulated device
Only damaged parts are subject to replacement. (1) Upper hinge plate seal (2) lower hinge plate seal (3) ejector spring (4) Outer seal of hinge plate (5) hinge bar (6) Inner seal...

Side windshield replacement
If the rubber seal is still in use, clean it. Place the rubber seal around the glass. If there is a decorative frame, press it into the seal. Place the cable or twine into the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3