Place the rubber seal around the glass. If there is a decorative frame, press it into the seal.
Place the cable or twine into the rubber groove 3. In doing so, spread the groove with a screwdriver and press the cable. The cable should lie deep in the groove. The ends of the cable should lie in the middle of the glass.
Insert the glass and slowly pull out the cable (see photo), while the edge of the rubber should lie on the sheet edge.
While the cable is slowly pulled out from the inside of the car, the second person should hit the glass from the outside with the palm of their hand to push it in.
(The information is available on the website VWmanual.ru)
Visitor comments