Removing
1. Before removing the wiper arm, make sure the motor is in the end position. Only in this position is it allowed to remove and install the wiper arm.
2. Remove covers (arrows) with a screwdriver (pic. 12.11).
3. Loosen nuts (arrows), but do not unscrew them completely (pic. 12.12).
4. Move the levers until they are free.
5. Turn off nuts and remove levers.
6. Remove the plastic screws (arrows) and remove both parts of the grille (pic. 12.13).
7. Remove bolts and nuts (arrows) and remove washers (pic. 12.14).
8. Disconnect the wiring connector from the wiper motor.
9. Remove the wiper frame assembly.
10. Disconnect levers 1 from the crank using a large screwdriver (pic. 12.15). Turn off a nut 4. Remove a crank 3. Turn off three bolts 2 fastenings of the electric motor of a screen wiper.
Installation
11. Set the electric motor to the extreme position by attaching the wiring connector for this.
12. Disconnect the wiring connector again and tighten the motor mounting bolts 2 (pic. 12.15). Tightening torque: 5 Nm.
13. Loosen the crank 3 and install first the connecting lever 2, then the connecting lever 1 (pic. 12.16). Install levers 1 and 2 in line and tighten nut 3 of the crank.
14. Further installation is carried out in the reverse order of removal.
15. Adjust the wiper arms (pic. 12.17).
Visitor comments