Contents: Removal ↓ Installation ↓
Removal
1. Wet the windshield with water, then turn the wiper on and off until the wiper arm returns to its original position.
2. Remove the ground cable from the battery.
3. Remove the wiper blades.
4. Using a thin screwdriver blade, remove the cover at the base of the wiper arm (the location of the casings is shown by arrows).
5. Loosen the windshield wiper arm mounting nut a few turns.
6. By moving the windshield wiper arm to the sides, loosen its fit on the axle, then unscrew the nut and remove the windshield wiper arm.
Initial position of windshield wiper blades
- A, B = 20+10 mm
Installation
1. Set the windshield wiper arm to a position where the windshield wiper blade is 20+10 mm from the base of the windshield.
2. Secure the wiper arm with the nut, tightening it to a torque of 20 Nm.
3. Install decorative caps on the wiper arm mounting nuts.
Visitor comments