Gasoline engine lubrication system Volkswagen Golf 3

Engine lubrication system
1 - sealing ring 2 - filling threaded connection 3 - oil measuring rod 4 - sealing ring 5 - oil pressure switch (0.3 bar) 6 - Oil pressure switch (1.8 bar) 7 - sealing ring 8 -...

Dismantling and installation of the crankcase
The oil pan can be removed with the engine still in place, but the front of the vehicle must be supported on jack stands. Remove the oil drain plug and allow the oil to drain....

Oil pump
Remove the crankcase. Remove the pump body mounting screws. Pull the pump down until the shaft disengages, then pull it out completely. Loosen the mounting plate screw and remove...

Oil filter
Replace the oil filter as per the instructions in the owner's manual or whenever the engine is repaired. To remove the filter, use the filter change key and tap the side of the...

Oil pressure control
1 - blue wire 2 - control lamp 3 - brown wire The engine oil pressure can be checked using a pressure gauge, which should be equipped with a connection element that allows it to...

Oil radiator
1 - screw, 25 Nm 2 - oil filter base 3 - sealing ring 4 - radiator 5 - nut, 25 Nm 6 - oil filter This type of engine uses a radiator inserted between the oil filter base and the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Golf 5 Golf 4 Golf 3

Golf 2 Golf 2 (petrol) Golf 1 (petrol) Golf 1 (diesel)