General information about the body and equipment The bodies of Golf, Jetta, Scirocco cars are subjected to anti-corrosion treatment during manufacture, therefore, since 1979, they have been guaranteed protection against...
Tool and equipment In addition to the main toolkit described in chapter " Basic rules for work ", you will need a set of screwdrivers of various lengths with Phillips and flat blades. Some parts are...
Front fender On Golf, Jetta, Scirocco models, the front fenders are bolted on and can be easily replaced without the use of special tools. The front fender is attached with ten bolts to the...
Bumpers Removal - Early Models with Separate Side Bumper Strips The front bumper consists of three sections - a cross member and two sidewalls (pic. R:3). Remove the bumper from the car...
Doors and upholstery Doors - replacement 1. Disconnect the wire "masses" from the battery. 2. The door stop is attached with a pin and a retaining ring. Remove the retaining ring from the underside of...
Door handles and locks Exterior Door Handle - Replacement 1. Remove the trim from the handle by prying it out with a small screwdriver. 2. Remove the handle screw and Belleville washer. The second...
Hood lock and its drive (cable) Rope replacement 1. Remove the cover from under the dashboard. 2. Remove the cover located on the side of the hood latch handle. 3. Open the hood, remove the grille and disconnect...
Radiator grille Replacement (pic. R:21) The radiator grilles differ depending on the car model, but the method of attaching them is similar. 1. Disconnect the clamps located along the upper cross...
Telescopic tailgate stop Replacement There are two types of gas-filled tailgate stops, distinguished by the grooves on the cylinder body. Stops of different types are interchangeable and are supplied...
Front seat Removing 1. Remove the protective covers from the seat rails, unscrew from the handle of the lock for the longitudinal movement of the seat (under the seat) small bolt and nut...
Speedometer cable Replacement 1. Disconnect the wire "masses" from the battery. 2. Remove the instrument panel (see chapter " electrical equipment ") and squeeze together the two tabs on both sides...
Dashboard Removal and installation 1. Disconnect the wire "masses" from the battery and remove the instrument panel (see chapter " electrical equipment "). 2. Remove the steering wheel (see...