General Suspension Information The Golf and Touran have the same running gear. Its main components are MacPherson strut front suspension and multi-link rear suspension. Front and rear suspension components are...
Car front suspension The bearing element of the front suspension is a three-component aluminum beam. This beam, which is a subframe, is connected to the body with silent blocks in six places. The...
Front suspension strut — removal and installation Removing 1. Golf cars. Remove the fairing grille, see the relevant chapter. 2. Golf Plus/Touran cars. Remove the glass cleaner motor, see relevant chapter. Attention! The...
Front suspension strut — disassembly 4.0. Suspension strut parts 1 - cover on the mudguard 2 - three bolts for fastening the upper suspension strut support to the mudguard. Tightening torque 15 Nm + 90°turn. The...
Drive shaft — removal and installation Golf cars can be equipped with different types of drive shafts, which differ in internal CV joints. The inner CV joint can be ball bearing or roller, which is also called...
Drive Shaft — Disassembly Attention! The CV joint drive shafts VL 90 and VL 100 have an identical design. Attention! Drive shafts with internal CV joint «tripod» AAR 3300i have an identical design. 6.0....
Drive shaft — replacement of the cuff CV joint Attention! Depending on the power plant, the inner CV joint can be ball bearing or roller «tripod». AT SHRUS «tripod» instead of six balls, three rollers are installed on the...
Hub bolt — removal and installation Removing 1. Place the manual transmission in neutral or, on vehicles with automatic transmission, move the control lever to N and apply the parking brake. 2. Remove the cap from...
Car rear suspension The rear four-link axle consists of a subframe, trailing arms, three wishbones on each side, and steering knuckles. This design provides mobility of the longitudinal and...
Rear suspension coil spring — removal and installation Removing 1. Mark the direction of rotation of the wheel with an arrow on the sidewall of the tire and loosen the wheel bolts. 2. Jack up the rear of the car, place it on jack...
Rear suspension shock absorber — removal and installation Removing 1. Mark the direction of rotation of the wheel with an arrow on the sidewall of the tire and loosen the wheel bolts. 2. Jack up the rear of the car, place it on jack...
Rear suspension shock absorber — disassembly and assembly Attention! Depending on the vehicle model, there may be an additional support ring between the compression buffer 4 and the protective tube 3. 12.0. shock absorber 1 - gas-filled...