Car clutch repair Volkswagen Golf 2

Clutch (petrol engine models)
The Colf II/Jetta II vehicles use a dry single-plate clutch with a diaphragm spring and mechanical cable drive. The pressure plate assembly is not repairable and must be replaced...

Clutch replacement (petrol)
The clutch can be removed without removing the engine from the vehicle. Remove the gearbox ( see here ). Using a center punch, mark the relative positions of the flywheel and...

Replacing the clutch cable (petrol)
The free travel of the clutch pedal should be 15-20 mm. It is adjusted by turning the adjusting nut (after loosening the lock nut) (figure 271) at the end of the cable sheath,...

Replacing the clutch release bearing (petrol)
The release bearing is used to engage and disengage the clutch. It must not be washed with liquids that remove grease. To remove the release bearing, release its clamps and remove...

Clutch (diesel models)
The Golf II/Jetta II with diesel engines also uses a dry single-plate clutch with a diaphragm spring and mechanical cable drive. The clutch pressure plate has a diameter of 200...

Clutch replacement (diesel)
Remove the gearbox. Mark the position of the casing in relation to the flywheel (for example, by marking both parts with a center punch). Loosen the six bolts securing the...

Replacing the clutch cable (diesel)
The clutch has a mechanical cable drive. The clutch pedal clearance is adjusted in the engine compartment on the clutch cable bracket, which is attached to the upper wall of the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Golf 5 Golf 4 Golf 3

Golf 2 Golf 2 (petrol) Golf 1 (petrol) Golf 1 (diesel)