Elements of car body Volkswagen Golf 2

General description of the car body
The body of the described vehicles has a load-bearing steel frame of a spatial type with welded external panels (the exception is the front fenders, which are mounted on...

Radiator grille — removal and installation
Removal Open the engine compartment hood. Press down on the middle sections of the retaining clips with a narrow screwdriver and at the same time pull the top section of the...

Upper cross member of the radiator frame
Removal Remove the bumper. Remove grill 1 (figure 458) radiator with a cover plate. Figure 458. Front body design: 1 - radiator grille; 2 - Upper cross member of the radiator...

Installation and adjustment of the hood lock
Install and screw the top cross member. Secure the top of the radiator to the rubber mounts. Connect the headlight and horn connectors. Attach the engine compartment hood release...

Front bumper — removal and installation
Attention! Operation of the vehicle without the front bumper or bumper holders is not permitted, as the subframe is not secured (front axle and engine beam). On all Golf II/Jetta...

Rear bumper — removal and installation
Removal Remove the bolts securing the left and right bumper brackets from the bottom. Pull the bumper back out of the side guides. Installation With the help of an assistant,...

Front wing — removal and installation
Removal Loosen the wheel bolts, raise the front of the vehicle and remove the wheel. Remove the front bumper. Remove the mudguard from the wheel arch. Unscrew the rubber bumper of...

Electrically adjustable rear view mirror
On vehicles produced since August 1987 with electric drive for outside rear-view mirrors, remove and install them in the manner described below. Removal Fix the mirror glass. To...

Rear view mirror without electric drive
Replace the non-electric rearview mirror from August 1987 as follows: Use a wide spatula to press the mirror glass, first from below and then from above. The glass is only...

Interior door trim — removal and installation
Remove button 1 (figure 464) door lock, then using a small screwdriver - socket 2. Figure 464. Interior door trim: 1 - door lock button; 2 - socket; 3 - overlay; 4 - door handle;...

Front seat — removal and installation
Removal Release the cover at the rear of the guide rail and remove it by sliding the cover backwards. Move the seat forward. Unscrew the cap nut 4 (figure 468) seat support....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Golf 5 Golf 4 Golf 3

Golf 2 Golf 2 (petrol) Golf 1 (petrol) Golf 1 (diesel)