Tailgate — removal, installation and fitting Removing 1. Disconnect the battery. 2. Remove an upholstery of a door. 3. Disconnect the plugs of the heater and rear window cleaner, as well as the additional brake light,...
Tailgate lock — removal and installation Removing 1. Disconnect the battery. 2. Remove an upholstery of a door. 3. Release the plug 4 of the lock 2 of the tailgate from the mount and disconnect it (see illustration). 4....
Trunk lock cover — removal and installation (Jetta) Removing 1. Disconnect the battery. 2. Open the trunk lid and remove the trunk lock cover. 3. Remove the cover from the handle 3 emergency trunk opening (see illustration). 4....
Upholstery of a back folding door — removal and installation Golf Cars Removing 1. Open the tailgate 5 (see illustration). 56.1. Upholstery of a back folding door. Golf Cars 1 - bolts 2 - lower part of the upholstery 3 - overlay opening for...
Door — removal and installation (Golf) Removing 1. Open the door. 2. Press the stop latch under the protective cover 6 (see arrow A in the illustration) and remove the front strut cover. 57.2. Front door. Golf Cars 1 -...
Door — fit (Golf) 1. Check door gaps. The door is installed correctly if, after closing, its gaps relative to adjacent body parts are parallel, and the door itself does not protrude or sink, its...
Front door — device (Golf) The doors of Golf cars are two-piece. On the inside of the door, power windows, door glass guides, a side rear-view mirror, speakers, and a door lock are fixed. The interior also...
The outer part of the front door — removal and installation Removing 1. Open the door. 2. Pry off the trim 12 with a plastic wedge, release its latches 13 and remove it from the door (see illustration). Detach the trim from the bottom. 3....
Side door amplifiers — removal and installation Attention! This chapter describes the procedure for removing and installing front door reinforcements that protect the door in a side collision. The reinforcement on the rear side...
Door glass — removal and installation Front door Removing 1. Remove the door upholstery. 2. Remove two plugs from the door frame 4 (see illustration). 3. Lower glass 1 down enough to provide sufficient access to the...
Power window motor — removal and installation Attention! Removal and installation of the power window motor are shown using the front door as an example. On the rear side door, the motor is removed and installed identically....
Power windows — removal and installation Front door power window Removing 1. Remove the outer part of the door. 2. Unscrew bolts of fastening and remove the panel of strengthening of a door. 3. Remove glass. 4. Unscrew...
External door handle — removal and installation Removing 1. Remove the lock cylinder. 2. Pry with a screwdriver and remove the latch 1 from the door handle (see illustration). 3. Pull handle 2 in the direction of arrow 3 and...
Lock cylinder — removal and installation Removing 1. Open the door and remove the cap from the locking screw 3 on the front side of the door (see illustration). 2. Pull door handle 1 and hold it in this position (see...
Door — removal and installation (Touran) Attention! The procedure for removing and installing the rear side door is the same as for the front. Removing 1. Open the door. 2. Press the stop latch under the protective cover...
Door lock — removal and installation (Touran) Lock, power window and loudspeakers are fixed on the carrier beam (bracket) doors. The door lock can only be removed together with the beam. Attention! The rear side door lock is...
Window regulator — removal and installation (Touran) Bearing beam front door The door lock, power window and loudspeakers are fixed on the carrier beam of the door. The window regulator can only be removed together with the support...
Power window motor — removal and installation (Touran) Attention! The procedure for removing and installing the power window motor is given using the front door as an example. On the rear side door, the procedure for removing and...
Door upholstery — removal and installation Golf Cars Driver's door 1. Remove trim 1 on the door armrest by prying it up with a plastic wedge 9 and pushing it up (see illustration). 73.1. Driver's door upholstery. Golf Cars...
Window regulator handle — removal and installation Removing 1. Displace spacer ring 2 by pushing it in the direction of the arrow (see illustration) and remove the handle from the shaft. Installation 2. Right side door. Slide the...