Attention! The procedure for removing and installing the power window motor is given using the front door as an example. On the rear side door, the procedure for removing and installing the motor is the same.
Removing
1. Remove the door upholstery.
2. Front door. Unscrew bolts 1 and remove bracket 2 (see illustration).
3. Raise the glass up and secure it in this position with tape or a plastic wedge.
4. Disconnect the battery.
5. Disconnect plugs from the electric window regulator motor, having wrung out their leaders.
6. Unscrew three bolts and remove the electric motor from a bearing beam of a door.
Installation
7. Install the power window motor in place, release the fixed glass and raise and then lower it to match the gear on the motor.
8. Tighten the motor mounting bolts to 3.5 Nm.
Attention! It is not necessary to apply more force when tightening, because in this case the plastic bushing will be damaged.
9. Connect the battery.
10. Connect the motor connectors and raise and lower the glass twice.
11. Reinstall the door upholstery.
Visitor comments