Removing
With the ignition off, disconnect the ground wire from the battery (-).
Attention: Follow the instructions given in chapter «Removing and installing the battery».
Remove the door mechanism holder, see relevant chapter above.
Insert a pry bar between the holder and the power window motor from the rear side of the door mechanism holder and press the power window drive away from the door mechanism holder.
Remove bolts -1- from front of door mechanism holder and remove power window motor.
Installation
Attach the electric window motor to the holder of the door mechanisms, align the drive and connect to the electric motor.
Tighten the power window motor mounting bolts to 3.5 Nm.
Caution: Do not overtighten the bolts, as the plastic sleeve may be damaged.
Install door mechanism holder, see relevant chapter above.
With the ignition off, connect the ground wire to the battery (-).
Attention: Follow the instructions given in chapter «Removing and installing the battery».
Visitor comments