Removal
Car with window lift handle: remove the handle, see the relevant chapter below.
Using screwdriver "2", carefully press the side cover "1" from behind the handle recess. In order not to damage the trim, place a gasket "3", for example, cardboard, underneath.
Insert a plastic wedge, such as HAZET 1965-20, into the gap and push the cover away from the handle recess.
Unscrew screw "1" located behind the cover.
Unscrew screws "2" from the bottom of the trim.
Using pressing pliers, such as HAZET 799-4, release the trim at the clamps from the door frame.
Unhook the cable traction from the back of the lining.
Disconnect the plug connectors from the rear side of the trim and remove the trim.
Installation
Check and replace the spacer clamps if necessary.
Installation is carried out in reverse order.
Only the door on the passenger side next to the driver/rear side door
Car with window lift handle: remove the handle, see the relevant chapter below.
Using a plastic wedge or flat-head screwdriver "2", push the trim "1" out of the door handle "3" and unscrew the screws "4".
Note: The picture shows a door handle that is not for the IBIZA vehicle.
Passenger side door next to the driver: remove the screws from the bottom of the trim.
Using pressing pliers, such as HAZET 799-4, release the trim at the clamps from the door frame.
Unhook the cable traction from the back of the lining.
Disconnect the plug connectors from the rear side of the trim and remove the trim.
Before installation, check and replace the spacer clamps if necessary.
Visitor comments