Car rear suspension Volkswagen Polo 4

Rear wheel suspension
The rear axle is suspended via separately replaceable coil springs and shock absorbers bolted to the axle beam and body. Attention: Welding and straightening work on the...

Removal and installation the rear coil spring
Removal Caution: If the rear axle is removed as an assembly (it is not described here), then the car must be firmly tied to the lift so that it does not slip off the lift. Use...

Removal and installation the rear shock absorber
Removal Automobile lift onto the trestles and remove the wheel. Place a suitable jack against the shock absorber receiver and support the bridge. Vehicle with headlights equipped...

Disassembly and assembly of the shock absorber
1 - gas-filled shock absorber Can be replaced separately. 2 - protective cap 3 - protective pipe 4 - Limiting buffer 5 — shock absorber bearing 6 - nut, 25 Nm Replace after each...

Checking the shock absorber
The presence of the following dynamic properties of the vehicle indicates a defect in the shock absorber: Long-term vibration of the body due to uneven road surfaces. The body...

Rear wheel hub
1 - Phillips head screw, 4 Nm 2 - brake drum 3 - protective cap Replace after each dismantling. 4 - 12-point wheel hub mounting nut, 175 Nm Self-locking, replace after each...

Removal the rear wheel hub
Removal Caution: High torque for loosening and tightening the wheel hub nut! Ensure that the vehicle is securely positioned on the trestles. If necessary, install the wheels and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Polo 4 Polo 3