Attention: Welding and straightening work on the supporting and guiding parts of the rear wheel suspensions is not allowed. Self-locking nuts and bolts must be replaced in case of repair.
1 — rear axle beam
2 - lower support
3 - coil spring
The surfaces of the turns must not be damaged.
4 - upper support
5 - Hexagon head bolt, 30 Nm + 90°
6 — shock absorber
7 — bolt, 40 Nm + 90°*
Ensure a mounting angle (approximately 95°) from the rear axle to the shock absorber.
8 - nut, self-locking *
9 — ABS speed sensor
Clean the inner surfaces of the hole and apply plastic grease G000650 to them.
10 - Hexagon head bolt, 8 Nm
11 — axle journal
Re-threading is not permitted.
12 — brake disc
13 - Phillips head screw, 4 Nm *
14 — cap*
15 - 12-sided wheel hub mounting nut, ⅕ Nm *
Self-locking, always replace.
16 - wheel hub with bearing
Does not require maintenance, adjustment work is not possible.
17 — bolts, 30 Nm + 90° *
18 - protective cover
19 — Handbrake cable holder *
20 — handbrake cable
21 - Handbrake cable holder
22 — bolt *
Insert from the outside.
23 - rubber-metal support
24 — nut, 45 Nm +90° *
Self-locking, always replace.
*) Always replace.
1 - wheel bolt, 120 Nm
2 - screw, 4 Nm *
3 - brake drum
4 - cap
5 - 12-sided wheel hub mounting nut, ⅕ Nm *
Self-locking, always replace.
6 - wheel hub with bearing
Single unit, does not require maintenance. If ABS is present, a ring for the sensor is installed.
7 — bolt, 30 Nm + 90° *
8 - brake shield with brake pads
9 — Handbrake cable holder *
10 — handbrake cable
Visitor comments