Internal elements of car body Volkswagen Polo 4

Important instructions for performing work operations and safety precautions
When working on interior fittings, the following instructions must be strictly followed. To press out plastic trims and overlays, it is recommended to use a plastic wedge, for...

Removal and installation spacer/spring clamps
Numerous plastic covers and trims are secured using spacer and spring clamps. Removal Fastening clip: Use a screwdriver or HAZET 799-4 pliers to pull out the clip and remove the...

Removal and installation the interior rearview mirror
Mirror without rain sensor Removal The mirror together with the base -1 - is pressed away from the holder with a downward diagonal movement "arrow" and thus the locking springs in...

Removal and installation the handle on the ceiling
Removal Fold the handle -1 - down. Use a screwdriver to pry up the plugs "2" and fold them down. Unscrew screws "3" and remove handle -1. Installation Installation is carried out...

Removal and installation the sun visor
Removal Unfasten the sun visor -1 - from the receiving support "2" Press the plug "6" and unscrew the screw "5". Detach the sun visor support "4" from the receiver and disconnect...

Removal and installation of the central console of POLO cars
Removal Note: For vehicles with a manual transmission, the gearshift lever head and boot do not need to be removed. For vehicles with an automatic transmission, the mode selector...

Removal and installation of the central console of IBIZA cars
Removal Remove the handbrake lever trim, see the relevant chapter below. Open the rear ashtray cover "4" and remove the ashtray from the center console "1" by moving it upwards....

Removal and installation the radio console/heating control unit trim
IBIZA Removal Remove the radio and glove compartment or, accordingly, remove the navigation system unit. Remove the -1/2- screws and, if necessary, remove the lower screws as...

Removal and installation of the instrument panel of POLO cars
Removal Disconnect the ground (-) cable from the battery. Attention: Follow the instructions given in the chapter " Removal and installation the battery ". Remove the airbag...

Removal and installation the handbrake lever trim
Removal Raise the handbrake lever "2" up. Insert a small screwdriver into the recess in the lever and turn it in the direction of arrow "A". Using a movement in the direction of...

Removal and installation the side covers of the instrument panel
Removal Using a small screwdriver or a plastic wedge, such as HAZET1965-20, press and remove the cover-1-on the side of the dashboard. Note: For IBIZA vehicles, place the tool...

Removal and installation of storage shelves of POLO cars
Removal Remove the covers from the center console, see chapter " Removal and installation the center console ". Driver's side: Move the steering wheel to the highest position....

Removal and installation the upper casing in the footwell of IBIZA vehicles
Removal Unscrew the "arrow" screws, detach the casing "2" from the holder -1 - and remove. Installation Installation is carried out in reverse order.

Removal and installation the glove compartment cover of IBIZA cars
Removal Remove the upper cover in the footwell on the passenger side next to the driver, see previous chapter . Press the right side cover of the instrument panel, see the...

Removal and installation of the glove compartment of POLO cars
Removal Remove the storage shelf on the passenger side next to the driver, see the relevant chapter above . Unscrew the "arrow" screws and pull out the glove box a little....

Removal and installation the A-pillar trim on POLO vehicles
Upper cladding Removal Insert a plastic wedge between the trim "2" and the door seal and detach the trim at the top near the spacer clamp "3" from the pillar A-4-. If present,...

Removal and installation the trim of the B pillar of POLO cars
Upper trim, 3-door model Removal Remove the threshold trim, see the relevant chapter below . Remove the rear side trim, see the relevant chapter below . Release the upper trim "2"...

Removal and installation the upper trim of the pillar C in a POLO vehicle
Upper trim, 3-door model Removal Remove the trunk lid support, see the relevant chapter below . Remove the rear seat belt eyelet, see the relevant chapter below . Using a downward...

Removal and installation of rear side trim of POLO vehicles
3-door model Removal Remove the threshold trim, see the relevant chapter below. Remove the rear seat cushion and backrest, see the relevant chapter below . Pull the side panel "1"...

Removal and installation the lower trim of the pillar C of POLO vehicles
5-door model Removal Remove the trunk lid support, see the relevant chapter below . Remove the upper trim of the C-pillar, see the relevant chapter above . Remove the threshold...

Removal and installation the threshold trim
POLO, 5-door model Removal Remove the rear seat cushion, see the relevant chapter below . Release the trim at the bottom of the C-pillar, see the relevant chapter above . Pull out...

Removal and installation the trunk lid support
POLO Removal Disconnect the ground (-) cable from the battery. Attention: Follow the instructions given in the chapter " Removal and installation the battery ". Remove the rear...

Removal and installation the side trim of the luggage compartment
POLO Removal Left side panel: remove the first aid kit. Lift and remove the luggage compartment bottom trim. Remove the rear end trim panel, see next chapter . Fold the rear seat...

Removal and installation the rear end trim
POLO Removal Lift and remove the luggage compartment bottom trim. Release trim "2" from the sides of the rear door frame "arrows A". Release the trim at the bottom from the inside...

Removal and installation of interior trims of IBIZA cars
Note: Before installation, check the spacer and spring clips for damage and replace the clips if necessary. Ensure that the door seal is positioned over the edge of the...

Removal and installation the front seat
POLO 1 - two rear bolts, 24 Nm 2 - two front bolts, 24 Nm 3 - locking pin Determines the position of the seat chassis. 4 - plug connector for a warning device that reminds you to...

Removal and installation the rear seat
Rear seat cushion Removal Note: The removal and installation of the rear seat cushion are described in relation to the composite cushion. The one-piece cushion is, in principle,...

Removal and installation the front seat belt
POLO, 3-door model 1 - seat belt height adjustment mechanism 2 - bolt, 40 Nm 3 - guide eye 4 - POLO: bolt, 8 Nm IBIZA: nut 8 Nm 5 - seat belt with tensioning mechanism There are 2...

Safety instructions for handling electrical seat belt tensioners
When working with seat belts and electrical tensioning mechanisms, strictly follow the following instructions. To prevent the seat belt tensioner from operating, with the ignition...

Removal and installation the front seat belt guide bracket
3-door model Removal Remove the threshold trim, see the relevant chapter above. Remove the rear side trim, see the relevant chapter above. Remove bolts "3" and -1 Remove the seat...

Removal and installation the front seat belt eyelet
5-door model Removal Remove the threshold trim, see the relevant chapter above . Unscrew bolt "1" and remove eyelet "2" of the front seat belt. Installation Tighten the front seat...

Removal and installation the front seat belt height adjustment mechanism
Removal Remove the upper trim of the B-pillar, see the relevant chapter above . Unscrew bolt "6" and remove guide eye "4". 1 - height adjustment lever for belt, 5 - seat belt....

Removal and installation the front seat belt buckle
Removal POLO: remove the front seat, see the relevant chapter above . IBIZA: Move the front seat back. Vehicles with a warning light that reminds you to fasten your seat belt:...

Removal and installation the rear seat belt of POLO cars
1 - Automatic seat belt retractor 2 - guide eye 3 - bolt, 40 Nm 4 - bolt, 40 Nm 5 - double lock 6 - 2 bolts, 40 Nm 7 - waist belt 8 - lock tongue 9 — rear belt eyelet 10 — bolt,...

Removal and installation the rear seat belt of IBIZA cars
Removal Fold the rear seat back forward. Remove the trunk lid support, see the relevant chapter above . Unscrew bolt "4", remove belt eyelet "3" and pull it out through the slot...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Polo 4 Polo 3