Rear seat cushion
Removal
Note: The removal and installation of the rear seat cushion are described in relation to the composite cushion. The one-piece cushion is, in principle, removed and installed in the same way.
Lift the seat cushion by the front edge, pull it forward, then lift it from behind and fold it forward.
Push the spring brackets "1" inside the "arrow" and pull them out of the hinges "2".
Remove the seat cushion from the vehicle.
Installation
Insert the seat cushion into the hinges, fold it back and secure it.
Rear seat back, composite
Removal
Note: The left backrest is shown in the picture. Removing the right backrest is done in the same way.
Fold the seat back -1 - forward.
From the outside of the backrest -1-, using a screwdriver "3", press back "arrow A" locking hook "2" and pull the backrest out of the holder with an upward movement.
Pull the backrest up slightly and remove it from the central rigid mount "4" (arrow B).
Installation
Slide the backrest "1" onto the central rigid fastening "4" and press it into the holder from the outside.
(The original article is available on the website: VWmanual.ru)
Tilt the backrest back.
Rear seat back, one piece
Removal
Fold the back of the rear seat "1" forward.
Remove two bolts "2" from the backrest near the central rigid mount.
At the side rigid fastenings "arrows" use a screwdriver to press back the hook "3" and remove the backrest with an upward movement.
Installation
Installation is performed in the reverse order. In this case, tighten the bolts at the central rigid mount to a torque of 40 Nm.
Visitor comments