Contents: Removal ↓ Installation ↓
1 - Automatic seat belt retractor
2 - guide eye
3 - bolt, 40 Nm
4 - bolt, 40 Nm
5 - double lock
6 - 2 bolts, 40 Nm
7 - waist belt
8 - lock tongue
9 — rear belt eyelet
10 — bolt, 40 Nm
Removal
Remove the seat cushion, see the relevant chapter.
Remove the trunk lid support, see the relevant chapter above.
Remove the upper trim of the C-pillar, see the relevant chapter above.
Unscrew bolt "10", remove belt eye "9" and pull it out through the slot in the trim.
Fold the rear seat back forward.
Unscrew bolt "3" and remove guide eye "2". Pay attention to the spacer ring and lining washer.
Unscrew bolt "4" and remove automatic seat belt retractor "1".
Installation
Installation is performed in the reverse order. In this case, tighten bolts -3/4/10- to 40 Nm.
Visitor comments