Removal and installation the upper trim of the pillar C in a POLO vehicle (VW Polo 4)

Upper trim, 3-door model

Removal

Remove the trunk lid support, see the relevant chapter below.

Remove the rear seat belt eyelet, see the relevant chapter below.

Using a downward movement, unfasten the rear headliner trim.

The text is copied from this portal vwmanual.ru

Fold the rear seat back forward.

3-door model



5-door model



Release trim "2" from pillar C in the direction from back to front and pull it out from under the rear door seal. 1 - spacer clamps. Remove the trim by moving it upwards.

Limousine model only: Insert a plastic wedge between the door trim and the door seal, remove the spacer clips and remove the trim from the C-pillar.

Pull the belt eyelet through the slot in the trim and remove the trim.

Installation

Check the clamps for damage and correct positioning on the trim; replace the clamps if necessary.

Installation is carried out in the reverse order. Make sure that the rear door seal is located above the edge of the trim.