Car rear suspension (2x4) Volkswagen Tiguan 1

Subframe device
The arrow indicates the direction of the vehicle's movement. 1 - Subframe 2 - Rear silent block 3 - Front silent block

Removal and installation of the subframe assembly with the units installed on it
Removal Remove the wheels. Remove the coil springs. Disconnect the electrical connectors located between the rear axle units and the body. Unscrew the bolt "arrow". Disconnect the...

Parts and assemblies of transverse levers and transverse rods
1 - Eccentric bolt for adjusting the camber, after loosening, check the wheel alignment angles 2 - Nut, M12x1.5, 95 Nm, self-locking, replace after each removal, tighten only in...

Details and assemblies of the rear left ground clearance sensor G76
Instructions: The ground clearance sensor is supplied only in assembly with a connecting rod, as well as upper and lower brackets. Replacement is carried out with the subframe...

Removal and installation the upper wishbone
Remove the wheel. Remove the coil spring. Disconnect the "arrow A" wire fastening of the speed sensor from the upper transverse arm. Unscrew screw "1". Mark, for example with a...

Removal and installation the lower wishbone
Measure the distance from the wheel center to the lower edge of the wheel arch. Remove the wheel. Remove the coil spring. Unscrew the bolt "arrow" securing the lower wishbone "1"....

Removal and installation the transverse tie rod
Remove the wheel. Remove the coil spring. Unscrew the nut "1" and disconnect the strut "2" from the stabilizer. Unscrew the bolt "arrow" securing the transverse tie rod "3"....

Parts and units of the hub bearing housing and trailing arm
1 - Lid 2 - Support bracket 3 - Stabilizer bar, connects the stabilizer to the trailing arm/hub bearing housing 4 - Bolt, tighten in the correct sequence, M12x1.5x40, 90 Nm and...

Removal and installation the wheel bearing housing
Remove the wheel. Remove the coil spring. Remove the hub bearing assembly. Remove the shield. Remove the ABS speed sensor from the hub bearing housing. Unscrew the bolt "arrow"....

Shock absorber and coil spring
1 - Lower spring gasket, when installing the end of the spring must be turned all the way 2 - Technological device, do not install again after removal 3 - Coil spring, it is...

Removal and installation a coil spring
Remove the wheel. Install the compression tool "3" on the spring. CAUTION: Ensure proper seating of the coil spring in the clamps -VAG 17S2/3A-2- (otherwise an accident is...

Removal and installation the shock absorber
Removal Remove the wheel. Remove the wheel arch liner. Remove the coil spring. Unscrew the "arrow" bolts. Unscrew the bolt "arrow". Remove the shock absorber. Installation...

Shock absorber repair
1 - Shock absorber, it is necessary to take into account the differences in the design of the chassis 2 - Sealing cuff 3 - Protective cover 4 - Support ring 5 - Shock absorber...

Anti-roll bar
1 - Anti-roll bar, it is necessary to take into account the differences in the design of the chassis 2 - Support, supports are always replaced in pairs 3 - Clamp 4 - Bolt, M8x30,...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian