- 1 - Lower spring gasket, when installing the end of the spring must be turned all the way
- 2 - Technological device, do not install again after removal
- 3 - Coil spring, it is necessary to take into account the differences in the design of the chassis
- 4 - Upper spring gasket
- 5 - Bolt, M14x1.5x85, 180 Nm, replace after each removal
- 6 - Bolt, M10x35, 50 Nm and tighten by 45°, replace after each removal
- 7 - Shock absorber, it is necessary to take into account the differences in the design of the chassis
- 8 - Washer
- 9 - Lower wishbone
- 10 - Hub bearing housing
Visitor comments