Vehicle drive shafts Volkswagen Tiguan 1

Cardan shaft device
Instructions: Repair work is not carried out on the cardan shaft. 1 - Gearbox with angular reduction gear 2 - Bolt with flanges and 12 edges for elastic coupling in front to the...

Removal and installation the propeller shaft
Instructions: Work with the cardan shaft should be carried out, if possible, on a two-support lift with a platform. Before removing, mark the location of all mating parts relative...

Removal and installation the rear final drive
Before lifting the vehicle, two holes must be drilled in the luggage compartment. The drilling points are marked "at the factory". Through these holes, it is possible to "access"...

Silent blocks
Instructions: Replace silent blocks "in pairs" (block top and bottom). 1 - Rubber-metal support "rear upper" with thrust washer, for removal and installation remove the thrust...

Places of installation of electrical/electronic units and components
1 - All-wheel drive control unit "J492", important signals from the engine control unit and the ABS + EDS control unit "J104" are transmitted to the all-wheel drive control unit...

All-wheel drive control unit J492
The Haldex coupling has been modified. The 2006 Tiguan is now equipped with a new Haldex coupling (generation "Haldex IV"). 1 - All-wheel drive control unit "J492", calibrated...

Removal and installation the Haldex coupling
Removal and installation of the Haldex coupling occurs with the main drive installed. 1 - Hexagon head bolt, tightening torque 50 Nm, 4 pcs. 2 - Haldex coupling with control unit...

Assembly and disassembly of the Haldex coupling (generation IV)
1 - O-ring, lubricate with Haldex coupling oil and insert, be sure to replace 2 - Haldex coupling housing 3 - All-wheel drive control unit "J492" with clutch opening degree...

Checking the oil level in the rear final drive or adding oil
The vehicle is in a horizontal position. Install the tray -VAS 6208- under the main gear. Unscrew bolt "1". The oil level is correct when the rear final drive is filled to the...

Adding oil to the Haldex coupling
The vehicle is in a horizontal position. Add oil for the Haldex couplings. Raise the vehicle. Place a container for the used oil underneath. Install the sump -VAS 6208- under the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar sections from other manuals for VW cars:
Transmission: Drive shafts Volkswagen Golf 2 (1984-1993, petrol)