Car rear suspension (4x4) Volkswagen Tiguan 1

Parts and units of the subframe, main gear
The arrow indicates the direction of the vehicle's movement. 1 - Subframe 2 - Rear silent block 3 - Front silent block 4 - Main gear 5 - Bolt, M12x105, 60 Nm and tighten by 90°,...

Removal and installation of the subframe assembly with the units installed on it
Removal Instructions: It is necessary to take into account that when performing further work requiring loosening of the hub bolt with a twelve-sided head, partial loosening of the...

Parts and assemblies of transverse levers and transverse rods
The arrow indicates the direction of the vehicle's movement. 1 - Eccentric bolt, after loosening, adjust the wheel alignment angles, do not turn the bolt beyond the adjustment...

Removal and installation the upper wishbone
Removal Remove the wheel. Remove the coil spring. Disconnect the "arrow A" wire fastening of the speed sensor from the upper transverse arm. Unscrew screw "1". Mark, for example...

Removal and installation the lower wishbone
Removal Remove the wheel. Remove the coil spring. Unscrew the bolt "arrow" securing the lower wishbone "1". Cars with automatic headlight range control Remove bolts "1" from the...

Parts and units of the hub bearing housing and trailing arm
The arrow indicates the direction of the vehicle's movement. 1 - Casing 2 - Support bracket 3 - Stabilizer bar link, connects the stabilizer to the trailing arm/hub bearing...

Shock absorber and coil spring
1 - Lower spring gasket, when installing the end of the spring must be turned all the way 2 - Technological device, do not install again after removal 3 - Coil spring, it is...

Shock absorber repair
1 - Shock absorber, it is necessary to take into account the differences in the design of the chassis 2 - Protective cover 3 - Bumper 4 - Upper support 5 - Nut, M10x1.0, 25 Nm,...

Anti-roll bar
The arrow indicates the direction of the vehicle's movement. 1 - Stabilizer, it is necessary to take into account the differences in the design of the chassis 2 - Support,...

Drive shaft device
1 - Outer CV joint, can only be replaced as an assembly, installation: push onto the shaft until it stops using a plastic hammer 2 - Bolt, 70 Nm and tighten by 90°, replace after...

Removal and installation the drive shaft
Removal Loosen the hub bolt. Remove the wheel. Remove the coil spring. Loosen the bolts securing the "arrow" of the lower wishbone "1" and the transverse rod "2" that connect them...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian