- 1 - Stabilizer, it is necessary to take into account differences in the design of the running gear
- 2 - Support, supports are always replaced in pairs
- 3 - Clamp
- 4 - Allen screw, M8x28, 25 Nm and tighten by 45°, replace after each removal
- 5 - Wheel bearing housing
- 6 - Nut, M10x55, 40 Nm, self-locking, replace after each removal
- 7 - Screw with internal polyhedron, replace after each removal
- 8 - Stabilizer link, connects stabilizer to trailing arm/wheel bearing housing
- 9 - Subframe
Visitor comments