- 1 - The lower spring gasket, when installing the end of the spring must be turned until it stops
- 2 - Technological device, after removal, do not install again
- 3 - Coil spring, differences in running gear must be taken into account
- 4 - Upper spring gasket
- 5 - Bolt, M14x1.5x70, 180 Nm
- 6 - Bolt, M10x35, 50 Nm and tighten by 45°, replace after each removal
- 7 - Shock absorber, it is necessary to take into account the differences in the design of the running gear
- 8 - Washer
- 9 - Lower wishbone
- 10 - Wheel bearing housing
Visitor comments