Power electrical devices of car Volkswagen Tiguan 1

Disconnecting and connecting the battery
1 - Battery terminal for ground cable, follow the instructions for attaching the terminals to the battery terminals 2 - Nut for fastening the battery terminal for the ground...

Removal and installation the battery
Caution: If the battery is not properly secured during installation, the following risks arise: reduced service life due to increased vibration (explosion hazard). Damage to the...

Starter (cars with 1.4 l TSI engines and MQ500 manual transmission)
1 - Starter 2 - Connecting the B+ wire to the starter 3 - Nut for fastening the connection of the B+ wire to the starter, M8, 15 Nm 4 - Starter mounting bolts, M12, 75 Nm 5 -...

Starter (cars with 2.0 l TDI engines and MQ500 manual transmission)
1 - Connecting the B+ wire to the starter 2 - Nut for fastening the connection of the B+ wire to the starter, M8, 15 Nm 3 - Starter mounting bolts, M12, 75 Nm 4 - Protective cap 5...

Starter (cars with 2.0 l TDI engines and AQ450 automatic transmission)
Removal and installation the starter Disconnect the battery. Move up to remove the engine cover "arrows". Unlock and disconnect the electrical connector "1" and loosen the spring...

Generator (1.4L TSI engine)
Fastening the B+ wire to the generator Caution: Incorrect tightening of the B+ wire will result in the following consequences: The battery will not be fully charged. Complete...

Removal and installation the generator (1.4 l TSI engine)
Disconnect the battery. Unlock the vacuum hose "arrow" and remove it. Pull the engine casing up from the rubber support "1" and remove it -in the direction of the arrow- forward....

Generator (2.0 l TDI engine)
1 - Hexagon head bolt with two rods, with washer, M4x20, M4x15, 2 Nm 2 - Generator protective cap 3 - Phillips head screws, M4x20, 2 Nm 4 - Protective cap for carbon brushes 5 -...

Removal and installation the generator (2.0L TDI engine)
Disconnect the battery. Pull up and remove the engine cover "arrows". Caution: Before removing, mark the direction of travel and the upper side of the new belt with the velcro....

Generator (2.0L TSI engine)
1 - Hexagon head bolt with flange, M8x110, 20 Nm 2 - Phillips head screws, M4x19, 2 Nm 3 - Washer, M5 4 - Phillips head screw, M5x21, 4.5 Nm 5 - Hexagon nut, M8, 15 Nm 6 - Hexagon...

Removal and installation the generator (2.0L TSI engine)
Disconnect the battery. Caution: Before removing, mark the outer side and direction of movement of the poly V-belt. The belt should be installed in accordance with the previously...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian