Caution: Before removing, mark the outer side and direction of movement of the poly V-belt. The belt should be installed in accordance with the previously applied mark (direction of belt movement). A belt that is installed incorrectly or against the direction of travel will be damaged.
Remove the poly V-belt. Remove the noise-insulating casing. Unscrew both lower "arrow" bolts securing the generator.
Unlock and disconnect connector "2". Unscrew oil pressure sensor "1" (key 24 mm). Unscrew both upper bolts of the "arrow" generator. Turn the generator slightly to the left to gain access to the connectors on the rear of the generator.
Unlock and disconnect the DF "1" wire connector.
Pry off and remove the protective cap "1".
Unscrew the fastening nut "2" and remove the loop terminal of the B+ wire "1" from the stud.
Unscrew both bolts securing the "arrow" and move the pipes and hose "1" upwards to make room for removing the generator.
Instructions: Do not disconnect the pipes and hose.
Remove the generator from the vehicle using an upward movement.
Installation is carried out in the reverse order, and the following instructions must be observed.
Caution: The belt must be installed in accordance with the previously applied mark (direction of belt movement)! Before installing the poly V-belt, check whether all units driven by it are securely fastened (generator, air conditioning compressor). Correctly install the poly V-belt on the pulleys!
Tighten the threaded connections to the specified tightening torques.
Visitor comments