- 1 - Anti-roll bar, it is necessary to take into account the differences in the design of the chassis
- 2 - Support, supports are always replaced in pairs
- 3 - Clamp
- 4 - Bolt, M8x30, 25 Nm and tighten by 45°, tighten alternately in several stages, skewing is unacceptable, replace after each removal
- 5 - Hub bearing housing
- 6 - Nut, 40 Nm, self-locking, replace after each removal, when tightening, hold the bolt by its internal hexagon
- 7 - Bolt
- 8 - Stabilizer bar, connects the stabilizer to the trailing arm/hub bearing housing
- 9 - Subframe
Visitor comments