1 - mirror housing
2 - outer lining
3 - mirror glass
Withdrawal
- Cover the bottom edge of the mirror housing with adhesive tape to prevent damage.
- With a flat plastic spatula, carefully press the glass of the mirror outwards - first from below, then at the top.
- Heated mirror: unplug connector at rear.
Safety note
When pressing the mirror glass, be sure to wear gloves or put a clean cloth on it. Risk of destruction and injury!
- Insert the glass of the mirror with guide pins into the receiver and fix it. In this case, press only on the central part of the glass.
4 - mirror bracket
Withdrawal
- Remove front door trim, see relevant chapter above.
- Using a plastic wedge, eg HAZET 1965-20, press out the triangular trim -6-.
- Unplug electrical connector -5-.
- Remove screws -7- and remove mirror together with bracket.
Installation
- Installation is carried out in reverse order.
5 - plug connector
6 - triangular pad
7 - screws, 8 Nm.
Visitor comments