Instructions: The following describes the work on removal and installation on the left side of the car. The work on removal and installation on the right side of the car is carried out in a similar manner.
Turn off the ignition. Starting from the upper end, pry up the upper trim of the handle "1" using the wedge "3409" and detach it from the door trim. Working from top to bottom, remove the upper trim "1" from the clips, and then remove it from the lower socket "2".
Unscrew two screws "1" (4.5 Nm). Unscrew two screws "2" (4.5 Nm).
Caution: When detaching the door trim, its fastening elements may be damaged! To prevent this from happening, it is necessary to strictly follow the description of the work below, detaching the fastening elements exactly in the specified place and in the specified sequence!
Detach the trim from the door -in the specified sequence-, releasing the fasteners using the wedge -T10039/1-.
Instructions: When detaching the door trim, the beveled surface of the wedge -T10039/1- must be directed towards the door.
Using a vertical upward movement, remove door trim "1" from the edge of the drop glass groove.
(View the original article on the resource: «vwmanual.ru»)
Pull outward the locking tongue "1" located on the inside of the upholstery. Pull the cable out of the guide with a backward movement. Disconnect the cable "2" from the inside door handle.
Disconnect the wiring harnesses from the trim (quantity depends on configuration) and turn the driver's door inner handle illumination lamp "L146" or the front passenger door inner handle illumination lamp approximately 90° counterclockwise "L147" "1". Remove the driver's door inner handle illumination lamp "L146" or the front passenger's door inner handle illumination lamp "L147" from the socket "2".
Visitor comments