Photo 3.1. Unscrewing the door lock plunger handle.
2. Remove the plastic cover. From the window lift handle, unscrew the mounting screw and remove the handle (see photos 6.2a and b).
Photo 8 2a. Removing the window lift mechanism handle cover.
Photo 8.2b. Unscrewing the window lift handle screw.
3. Pry and remove the small panels from the armrest/door handle and unscrew the mounting screws (see photo 8.3).
Photo 8.3. Removing the armrest/handle screw.
4. Pry and remove the trim from the inside door lock handle to gain access to the mounting screw. Unscrew the screw and remove the handle (see photos 8.4a and b).
Photo 8.4a. Removing the inner door lock handle cover.
Photo 8.4b. Removing the screw of the inner door lock handle.
5. Insert your fingers or a wide screwdriver between the edge of the trim panel and pry the panel to release the retaining clips (see photo 8.5).
Photo 8.5. Removing the inner door trim panel.
6. Remove the panel and carefully detach the waterproof screen (see photo 8.6).
Photo 8.6. Removing the waterproof screen from the door.
7. Reinstallation is accomplished by following the above steps in reverse order, but insert the foil sections of the waterproof screen into the door openings as shown in Figure 12.16.
Figure 12.15. Waterproof door screen (Section 8).
Figure 12.16. Foil screen section (indicated by the arrow) (Section 8).
Visitor comments