Removal and installation of front fenders In Volkswagen Kafer cars, the frame and body are bolted together. Both parts perform load-bearing functions and together form the rigid body of the car, to which the wings,...
Removal and installation of rear fenders Removing Loosen the rear wheel mounting bolts, raise the rear of the vehicle and place it on stands. Remove wheel. Remove the tail lights and pull the wiring harness back. Remove...
Removing and installing the trunk lid Removing Mark the position of the tailgate on the left and right, as well as the position of the hinge with a scriber (this facilitates the installation of the old cover in its...
Removal and installation of the trunk lid lock Removing Loosen the two hex bolts on the top of the lock. Remove the rod with the lining and the upper part of the lock. In the lock hole, loosen the stopper tightening bolts. Cut...
Removal and installation of a cowl Removing Open the hood. Remove the air filter from the engine and cover the suction pipe with something. Disconnect the wire from the license plate light and remove the light from...
Removal and installation of the lock of a cowl Removing Loosen the three bolts on the inside of the hood. Hold the lock with your hand and remove the rod. Remove lock. Installation Check the lock, rod and pads, replace if...
Checking the drains of the sliding roof (cabriolet) Water entering the sliding roof cutout flows down the drains located in its front and rear slopes. The front drain can be cleaned from above with compressed air or flexible steel...
Sliding roof seal replacement (cabriolet) If the sliding roof seal is damaged, it can be replaced. Worn seals in the roof cutout must be removed and replaced with new ones. Long strips are glued into the roof cutout with...
Removal and installation of doors Removing Loosen the door stop on the hinge. Make marks with a scriber on the hinge and frame (see arrow). Remove plugs for fixing bolts from casing. Let loose (first by hitting...
Door fixing plate adjustment If the door play cannot be eliminated by adjusting the fixing plate, it is not necessary to replace it. In many cases, it is sufficient to lay a sheet gasket 0.5-1.5 mm thick...
Removal and installation of a covering of doors Removing Use a screwdriver to push out the handle cup of the inside door opener and unscrew the Phillips screw from the cup. Remove the power window handle. To do this, remove the...
Removal and installation of windows Removing Remove door trim. Loosen the 4 hex bolts on the power window. Move glass up. Unscrew the 5 hex bolts and the hex bolt of the vent on the inner door trim. Press window...
Removal and installation of door handles and lock cylinders Removing Loosen the cross-head screw near the door lock. Pull forward and remove the door handle. To remove the lock cylinder, insert the key into the lock (otherwise the cylinder...
Replacement of windshield and side windows If the old glass seal is to be reused, clean it. Lay the seal around the glass. If there is a decorative frame, insert it into the seal. 1 - decorative frame; 2 - glass; 3 -...