Removing
Open the hood.
Remove the air filter from the engine and cover the suction pipe with something.
Disconnect the wire from the license plate light and remove the light from the hood.
Unscrew two bolts from the hinges of the hood and, overcoming the tension of the spring, remove the hood up. In doing so, unhook the spring from the upper cutouts.
Installation
Raise the hood slightly. Holding it at an angle, put the spring in place. Press the hood up a little and fasten to the second loop.
Move the hood in the elongated holes so as to ensure its uniform fit and seal. Tighten the bolts and by opening and closing a few times check that the hood fits well into the lock.
Visitor comments