Car clutch repair Volkswagen Beetle 1

Description of the clutch design
The clutch is mounted on the engine flywheel. Its main parts are the pressure and driven disks. The primary shaft of the gearbox contains a maintenance-free clutch release...

The principle of operation of the clutch
When engaged, the clutch pressure plate is pressed by a diaphragm spring against the driven disk and flywheel, thereby establishing a rigid kinematic connection between the engine...

Removal, checking and installation the clutch
Removal Remove the engine (see section " Removal and installation the engine "). If the old clutch is to be installed again, then before removing the pressure plate, mark it and...

Removal and installation the clutch cable
Removal Loosen the left rear wheel mounting bolts, lift the vehicle and place it on supports. Remove the wheel. Loosen the clutch cable wing nut on the clutch release lever....

Checking and adjusting the deflection of the clutch cable guide
Attention! The cable guide must have a deflection of B=25-45 mm. Achieve the required pre-deflection of the cable guide by installing or removing suitable washers between the...

Adjusting the clutch pedal free play
Loosen the left rear wheel mounting bolts. Raise the vehicle and place it on supports. Remove the wheel. If necessary, clamp the end of the clutch cable with pliers and tighten...

Clutch malfunctions and how to fix them
Malfunction Cause Solution The clutch is slipping The pedal free play is too small Increase free play to 20 mm The driven disk linings have hardened or become oily Replace the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Caddy 3 Beetle LT 2D LT 28