Preparation for dismantling the door trim: 1 - plastic caps for armrest locking screws; 2 - door handle; 3 - button (5) for adjusting the mirror; 4 - window lift handle axis; 6 - armrest lock; 7 - locking screw of the inner handle insert.
In newer models, this requires turning the armrest 90 degrees upward and removing it from the top connection.
Remove the handle insert from the interior door handle frame.
Remove the Phillips head screw from the inner handle frame; remove the frame.
The door handle is secured from the outside by a screw (1) located under the decorative trim (2), as well as a screw (2) at the end of the door.
(View the original on the website: VWmanual.ru)
Slide the cover off the window handle and set it aside.
Loosen the Phillips head screw located under the casing; remove the window lift handle.
Remove the button that adjusts the outside mirror.
In new models, remove the locking button.
At the front and bottom of the trim, unscrew two or three cross-head screws; the screws are located under the plastic caps.
Carefully pull the door trim from below near one of the corners so that the clips come out of the door leaf.
Take hold of the trim from behind with your hand and carefully remove the trim in a circle.
the pocket is secured with six Phillips-head screws on the inside of the trim.
The seal on the inside of the trim must not be damaged, otherwise moisture may penetrate and the back of the door trim will become damp.
Before installation, check whether the fixing clamps are still intact.
If necessary, move the clamps so that they are located near the corresponding holes in the door leaf.
The window lift handle screw should be installed with a small amount of grease so that it rotates easily when raising and lowering the window.
Visitor comments